2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Engine Coolant Temperature Receiver Gauge Malfunction

Circuit diagnosis · Vehicles built Nov 2012 – Jul 2014

Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014

DESCRIPTION

In this circuit, the meter CPU receives engine coolant temperature signals from the ECM using the CAN communication system (CAN V1 Bus). The meter CPU displays engine coolant temperature that is calculated based on the data received from the ECM.

WIRING DIAGRAM

E143765E55

INSPECTION PROCEDURE

HINT:
If there is an open or short in the engine coolant temperature sensor circuit, the ECM stores the DTCs. Troubleshoot the SFI System (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication DTC is output (Click here).

    Result 
    Result
    Proceed to
    CAN communication DTC is not output
    A
    CAN communication DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (WATER TEMPERATURE METER OPERATION)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Combination Meter / Active Test.

  1. According to the display on the intelligent tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Water Temperature Meter Operation
    Engine coolant temperature receiver gauge
    LOW, NORMAL or HIGH
    Perform the test with the vehicle stopped and the engine idling.

    OK:
    Engine coolant temperature receiver gauge indication is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3. READ VALUE USING INTELLIGENT TESTER (COOLANT TEMPERATURE)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Combination Meter / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Coolant Temperature
    Engine coolant temperature/
    Min.: 0 (32), Max.: 127.5 (261.5)
    After warming up:
    75 to 105 (167 to 221)
    Unit: °C (°F)

    OK:
    Engine coolant temperature value displayed on the intelligent tester is almost the same as the engine coolant temperature receiver gauge indication.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


4. CHECK ENGINE CONTROL SYSTEM
  1. Check if a engine control DTC is output (Click here).

    Result 
    Result
    Proceed to
    Engine control DTC is not output
    A
    Engine control DTC is output
    B



B
GO TO SFI SYSTEM (Click here)
A

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Engine Coolant Temperature Receiver Gauge Malfunction (Aug 2012 – Oct 2012)Engine Coolant Temperature Receiver Gauge Malfunction (from Aug 2014) →