2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2011

Also covers:

Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012

DESCRIPTION

The combination meter communicates with the ECM and skid control ECU via the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
U0100
When either of following conditions detected:
  1. Vehicle speed 5 km/h (3.1 mph) or more and IG voltage 10.5 V or higher
  2. No communication with ECM continues for 3 seconds or more (No communication to ECM or skid control ECU continues for 60 seconds or more)
  1. CAN communication system
  2. ECM
U0129
When either of following conditions detected:
  1. 15 seconds have elapsed since engine started and IG voltage 10.5 V or higher
  2. No communication with skid control ECU continues for 3 seconds or more (No communication with ECM or skid control ECU continues for 60 seconds or more)
  1. CAN communication system
  2. Skid control ECU

INSPECTION PROCEDURE


1. CONFIRM DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Check for DTCs and note any codes that are output (Click here).

  1. Clear the DTC (Click here).

  1. Recheck for DTC (Click here).

    Result 
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← B1500 Fuel Sender Open Detected (from Nov 2012)U0100 Lost Communication with ECM / PCM "A" (+ U0129, U0151) (Aug 2011 – Jul 2012) →