The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1.
INSTALL REAR SEAT OUTER BELT ASSEMBLY
Check the angle of inclination required to lock the retractor.
Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
NOTICE:
Do not disassemble the retractor.
If the operation is not as specified, replace the rear seat outer belt.
Hook the lower stay of the retractor onto the 2 body hooks and provisionally install the retractor with the 2 bolts.
Tighten bolt A and then bolt B.
Torque:
8.5 N*m{
87 kgf*cm
, 75 in.*lbf
}
for bolt A
42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
for bolt B
Install the through anchor with the bolt.
Torque:
42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
Make sure that the shoulder anchor rotates smoothly.
Check that the ELR locks.
NOTICE:
Perform the check with the front seat outer belt installed.
With the belt installed, check that the belt locks when it is pulled out quickly. If the operation is not as specified, replace the rear seat outer belt.
2.
INSTALL ROOF SIDE INNER GARNISH
Pass the rear seat outer belt through the slit in the roof side inner garnish.
Engage the 7 clips and the claw and install the roof side inner garnish.
Tighten the bolt.
Torque:
5.5 N*m{
82 kgf*cm
, 71 in.*lbf
}
Install the clip.
Engage the claw and close the cover.
3.
INSTALL DECK TRIM SIDE PANEL ASSEMBLY
for RH Side:
Engage the 6 clips and the 8 claws and install the deck trim side panel.
Tighten the 4 screws.
for LH Side:
Engage the 6 clips and the 8 claws and install the deck trim side panel.
Tighten the 3 screws.
Install the anchor plate with the bolt.
Torque:
42 N*m{
428 kgf*cm
, 31 ft.*lbf
}
Make sure that the shoulder anchor plate rotates smoothly.
4.
INSTALL LAP BELT OUTER ANCHOR COVER
Engage the 3 claws and install the lap belt outer anchor cover.