REMOVAL
Removal / installation · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010
| 1. REMOVE V-BANK COVER |
Raise the front of the V-bank cover to disengage the 2 pins.

Remove the 2 V-bank cover hooks from the bracket.
Remove the V-bank cover.
Text in Illustration *1
Pin
*2
Hook
| 2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 4 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.

| 3. REMOVE UPPER RADIATOR SUPPORT SEAL |
Disengage the 7 clips, then remove the radiator support seal.

| 4. REMOVE FAN SHROUD |
Disconnect the reservoir hose from the radiator.

Loosen the 4 nuts holding the fluid coupling fan.

Remove the fan and V-ribbed belt (Click here).
Disengage the claw to open the hose clamp and disconnect the oil cooler tube from the fan shroud.

Remove the bolt from the reserve tank.
Remove the 2 bolts from the fan shroud.
Disengage the claws of the shroud from the radiator as shown in the illustration.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
- NOTICE:
- Be careful not to damage the radiator core.
Remove the fan pulley from the water pump.
| 5. REMOVE FAN |
![]() ![]() |
Remove the 4 nuts and the fan from the fluid coupling.

