2011-2016 FJ Cruiser · Service Manual RESTRAINTS

B1610/13 Front Airbag Sensor RH Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2008

DESCRIPTION

The front airbag sensor RH consists of parts including the diagnostic circuit and the frontal deceleration sensor.
When the center airbag sensor assembly receives signals from the frontal deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1610/13 is set when a malfunction is detected in the front airbag sensor RH.
DTC No.
Detection Condition
Trouble Area
B1610/13
  1. Front airbag sensor RH malfunction
  2. Center airbag sensor assembly malfunction
  1. Front airbag sensor RH
  2. Center airbag sensor assembly

WIRING DIAGRAM

H101947E08

INSPECTION PROCEDURE

NOTICE:
In order to prevent unexpected airbag deployment, disconnect the following connectors before inspecting parts such as wire harnesses, if the application of tester probes to the center airbag sensor assembly connector is necessary.

  1. Turn the ignition switch off.
  2. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
  3. Disconnect the connector from the center airbag sensor assembly.
  4. Disconnect the connectors from the steering pad.
  5. Disconnect the connectors from the front passenger airbag assembly.
  6. Disconnect the connector from the front seat outer belt assembly LH.
  7. Disconnect the connector from the front seat outer belt assembly RH.
  8. Disconnect the connector from the front seat side airbag assembly LH.
  9. Disconnect the connector from the front seat side airbag assembly RH.
  10. Disconnect the connector from the curtain shield airbag assembly LH.
  11. Disconnect the connector from the curtain shield airbag assembly RH.

1. CHECK FRONT AIRBAG SENSOR RH

  1. C148689E18
    Turn the ignition switch off.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Interchange the front airbag sensor LH with RH and connect the connectors to them.

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here ).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check the DTCs (Click here ).

    Result:
    Result
    Proceed to
    DTC B1610/13 is output.
    A
    DTC B1615/14 is output.
    B
    DTC B1610/13 and B1615/14 are not output.
    C

    HINT:
    DTCs other than DTC B1610/13 and B1615/14 may be output at this time, but they are not related to this check.



A
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)

B
REPLACE FRONT AIRBAG SENSOR RH (Click here)
C

USE SIMULATION METHOD TO CHECK (Click here)


← B1608/84 Front Satellite Sensor Bus LH Initialization Incomplete (+ B1617/84, B1618/84) (from Aug 2008)B1615/14 Front Airbag Sensor LH Malfunction (from Aug 2008) →