2011-2016 FJ Cruiser · Service Manual BRAKE

C0371/71 Yaw Rate Sensor (Test Mode DTC)

Diagnostic trouble codes · Vehicles built Jul 2007 – Jul 2009

Also covers:

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010

DESCRIPTION

The skid control ECU receives signals from the yaw rate sensor and deceleration sensor via the CAN communication system.
The deceleration sensor is built into the yaw rate sensor.
If there is trouble in the bus lines between the yaw rate sensor and deceleration sensor and the CAN communication system, DTC U0123/62 (yaw rate sensor communication trouble) and U0124/95 (deceleration sensor communication trouble) are output.
DTC No.
DTC Detecting Conditions
Trouble Areas
C0371/71
Detected only during test mode
  1. Yaw rate and deceleration sensor
  2. Yaw rate and deceleration sensor circuit
  3. CAN communication system
C1232/32
At vehicle speed of 10 km/h (6 mph) or more, signal from either GL1 or GL2 does not change for 30 seconds or more.
  1. Yaw rate and deceleration sensor
  2. Yaw rate and deceleration sensor circuit
  3. CAN communication system
C1234/34
Sensor malfunction signal received from yaw rater sensor.
  1. Yaw rate and deceleration sensor
  2. Yaw rate and deceleration sensor circuit
  3. CAN communication system
C1243/43
Following condition repeats 16 times.
  1. GL1 and GL2 do not change by more than 2LSB when vehicle decelerates from 30 km/h (19 mph) to 0 km/h (0 mph).
  1. Yaw rate and deceleration sensor
  2. Yaw rate and deceleration sensor circuit
  3. CAN communication system
C1244/44
When either of following (1 or 2) detected:
  1. Both of following conditions continue for at least 60 seconds.
    1. Vehicle stopped.
    2. Difference between GL1 and GL2 does not drop below 0.4 G once it reaches 0.6 G or more.
  2. Data malfunction signal received from deceleration sensor.
  1. Yaw rate and deceleration sensor
  2. Yaw rate and deceleration sensor circuit
  3. CAN communication system
C1245/45
Following condition continues for at least 60 seconds.
  1. Difference between values calculated from deceleration sensor value and vehicle speed exceeds 0.35 G.
  1. Yaw rate and deceleration sensor
  2. Yaw rate and deceleration sensor circuit
  3. CAN communication system
C1279/79
Detected only during test mode
  1. Yaw rate and deceleration sensor
  2. Yaw rate and deceleration sensor circuit
C1381/97
Deceleration sensor power source malfunction signal received for at least 10 seconds at speed of more than 3 km/h (2 mph).
  1. Yaw rate and deceleration sensor
  2. Yaw rate and deceleration sensor circuit

WIRING DIAGRAM

C164936E01

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and deceleration sensor, perform zero point calibration (Click here).

HINT:
When U0073/94, U0123/62, U0124/95 or U0126/63 are output together with C1232/32 or C1234/34, inspect and repair the trouble areas indicated by U0073/94, U0123/62, U0124/95 or U0126/63 first.


1. CHECK DTC
  1. Clear the DTC(s) (Click here).

  1. Check if the DTCs U0073/94, U0123/62, C1210/36 and/or C1336/39 are detected (Click here).

    Result:
    Result
    Proceed to
    DTC U0073/94, U0123/62, C1210/36 and/or C1336/39 not output
    A
    DTC U0073/94 and/or U0123/62 output
    B
    DTC C1210/36 and/or C1336/39 output
    C



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)

C
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2. INSPECT YAW RATE AND DECELERATION SENSOR

  1. C121701E03
    Disconnect the yaw rate and deceleration sensor connector.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E34-5 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E34-1 (GND) - Body ground
    Ignition switch OFF
    Below 1 Ω


Result:
Result
Proceed to
OK (When troubleshooting in accordance with DTC CHART)
A
OK (When troubleshooting in accordance with PROBLEM SYMPTOMS TABLE)
B
NG
C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE YAW RATE AND DECELERATION SENSOR (Click here)


← C0278/11 Open in ABS Solenoid Relay Circuit (+ C0279/12) (Jul 2007 – Oct 2010)C0371/71 Yaw Rate Sensor (Test Mode DTC) (+ 7 more codes) (Aug 2009 – Oct 2010) →