2011-2016 FJ Cruiser · Service Manual BRAKE

C0278/11 Open in ABS Solenoid Relay Circuit

Diagnostic trouble codes · Vehicles built Jul 2007 – Oct 2010

Also covers:

DESCRIPTION

The solenoid relay supplies power to the ABS solenoid and TRC solenoid.
After the ignition switch is turned to ON, the vehicle speed has reached 6 km/h (4 mph) and the solenoid is determined to be normal by the initial check self- diagnosis, the relay switches on. If any open or short circuits are detected, the relay switches off.
These DTCs may be set if the voltage supply to the solenoid relay (+BS) falls below the DTC detection threshold due to the battery or generator outputs being insufficient.
DTC No.
DTC Detecting Condition
Trouble Areas
C0278/11
When either of following conditions detected:
  1. Both of following conditions continue for at least 0.2 seconds.
    1. IG voltage between 9.5 V and 17 V.
    2. Relay contact open when relay ON
  2. Both of following conditions continue for at least 0.2 seconds.
    1. IG voltage 9.5 V or less when relay ON.
    2. Relay contact remains open.
  1. ABS SOL fuse
  2. +BS terminal circuit
  3. Master cylinder solenoid (skid control ECU)
C0279/12
Following condition continues for at least 0.2 seconds.
  1. Relay contact closed immediately after turning IG switch to ON when relay OFF.
  1. ABS SOL fuse
  2. +BS terminal circuit
  3. Master cylinder solenoid (skid control ECU)

WIRING DIAGRAM

C164935E01

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. INSPECT FUSE (ABS SOL)

  1. C135278E01
    Remove the ABS SOL fuse from the engine room R/B No. 2.

  1. Measure the resistance.

    Standard resistance:
    Below 1 Ω



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


2. CHECK SKID CONTROL ECU TERMINAL VOLTAGE (+BS)

  1. C121700E77
    Disconnect the skid control ECU connector.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Specified Condition
    A4-31 (+BS) - A4-1, 32 (GND1, GND2)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BODY GROUND)

  1. C124799E04
    Disconnect the skid control ECU connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A4-1, 32 (GND1, GND2) - Body ground
    Below 1 Ω
    A5-4 (GND3) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Check if the same DTC(s) is output (Click here).



B
END
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C0226/21 SFR Solenoid Circuit (+ 7 more codes) (Jul 2007 – Oct 2010)C0371/71 Yaw Rate Sensor (Test Mode DTC) (+ 7 more codes) (Jul 2007 – Jul 2009) →