2011-2016 FJ Cruiser · Service Manual BRAKE

C1242 Open Circuit in IG1/IG2 Power Source Circuit

Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2012

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

If there is a problem with the master cylinder solenoid (skid control ECU) power supply circuit, the skid control ECU outputs the DTC and prohibits operation under the fail-safe function.
If the voltage supplied to terminal IG2 is not within the DTC detection threshold due to malfunctions in parts such as the battery and generator circuit, this DTC is stored.
DTC Code
DTC Detection Condition
Trouble Area
C1242
Vehicle speed 3 km/h (2 mph) or more and voltage of skid control ECU terminal IG2 remains at below 6.5 for more than 7 seconds.
  1. Battery
  2. IGN fuse
  3. Charging system
  4. Harness or connector
  5. Master cylinder solenoid (skid control ECU)

WIRING DIAGRAM

C230319E02

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the master cylinder solenoid, perform zero point calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT SKID CONTROL ECU (IG2 TERMINAL)

  1. C139133E02
    Disconnect the skid control ECU A5 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A5-1 (IG2) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT SKID CONTROL ECU (GND TERMINAL)

  1. C124799E53
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A4-1 (GND1) - Body ground
    Always
    Below 1 Ω
    A4-32 (GND2) - Body ground
    Always
    Below 1 Ω
    A5-4 (GND3) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is output (Click here).

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1241/41 Low Battery Positive Voltage (Jul 2007 – Oct 2010)C1242 Open Circuit in IG1/IG2 Power Source Circuit (from Aug 2012) →