C1242 Open Circuit in IG1/IG2 Power Source Circuit
Diagnostic trouble codes · Vehicles built from Aug 2012
Versions by build date: Nov 2010 – Jul 2012 from Aug 2012
DESCRIPTION
If there is a problem with the master cylinder solenoid (skid control ECU) power supply circuit, the skid control ECU outputs the DTC and prohibits operation under the fail-safe function.If the voltage supplied to terminal IG2 is not within the DTC detection threshold due to malfunctions in parts such as the battery and generator circuit, this DTC is stored.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1242 |
Vehicle speed 3 km/h (2 mph) or more and voltage of skid control ECU terminal IG2 remains at below 6.5 for more than 7 seconds. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. INSPECT SKID CONTROL ECU (IG2 TERMINAL) |
Disconnect the skid control ECU A5 connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
A5-1 (IG2) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Skid Control ECU)
|
|
||||
| OK | |
| 2. INSPECT SKID CONTROL ECU (GND TERMINAL) |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
A4-1 (GND1) - Body ground
Always
Below 1 Ω
A4-32 (GND2) - Body ground
Always
Below 1 Ω
A5-4 (GND3) - Body ground
Always
Below 1 Ω
Text in Illustration *a
Front view of wire harness connector
(to Skid Control ECU)
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Check if the same DTC is output (Click here).
- HINT:
- Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
