2011-2016 FJ Cruiser · Service Manual SECURITIES

B279A Theft Deterrent System Communication Line High Fixation

Diagnostic trouble codes · Vehicles built from Nov 2010

Versions by build date: Aug 2009 – Oct 2010 from Nov 2010

DESCRIPTION

If the communication line (EFIO-IMI) to the transponder key ECU assembly is stuck on HI output, the ECM outputs this DTC.
DTC No.
DTC Detection Condition
Trouble Area
B279A
When communication line (EFIO-IMI) between ECM and the transponder key ECU is stuck on HI output
  1. Wire harness
  2. Transponder key ECU assembly
  3. ECM

WIRING DIAGRAM

B203372E23

INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
  2. If the ECM is replaced, register the ECU communication ID.


1. CHECK DTC OUTPUT
  1. Recheck for DTC (Click here).

    HINT:
    If any DTCs other than DTC B279A are output, troubleshoot those DTCs first.

    Result:
    Result
    Proceed to
    DTC B279A output reoccurs
    A
    DTC B279A and other DTCs output reoccur
    B



B
GO TO DTC CHART (Click here)
A


2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)
B242540E02
  1. Disconnect the E80 ECU and E81 ECM connectors.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E80-13 (EFIO) - E81-14 (IMI)
    Always
    Below 1 Ω
    E80-13 (EFIO) - Body ground
    Always
    10 kΩ or higher

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E80-13 (EFIO) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK TRANSPONDER KEY ECU ASSEMBLY (OUTPUT)
  1. Reconnect the E80 ECU and E81 ECM connectors.

  1. B242908E02
    Measure the waveform.
    Waveform 1 (Reference) 
    Item
    Content
    Terminal No. (Symbols)
    E80-13 (EFIO) - E80-16 (GND)
    Tool Setting
    5 V/DIV., 50 ms./DIV.
    Condition
    Ignition switch ON
    Text in Illustration 
    *1
    Component with harness connected
    (Transponder Key ECU Assembly)



NG
REPLACE ECM (Click here)
OK


4. REPLACE TRANSPONDER KEY ECU ASSEMBLY
  1. Replace the transponder key ECU assembly (Refer to the Service Bulletin).


NEXT


5. KEY REGISTRATION
  1. Register the key (Refer to the Service Bulletin).


NEXT


6. ECU COMMUNICATION ID REGISTRATION
  1. Register the ECU communication ID (Refer to the Service Bulletin).


NEXT


7. CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    B279A output does not reoccur.



NG
REPLACE ECM (Click here)
OK

END


← B279A Theft Deterrent System Communication Line High Fixation (Aug 2009 – Oct 2010)B279C Theft Deterrent System Presence Detection (from Aug 2009) →