2011-2016 FJ Cruiser · Service Manual BRAKE

C1436 Yaw Rate Sensor Malfunction

Diagnostic trouble codes · Vehicles built Aug 2011 – Jul 2012

Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012

DESCRIPTION

Refer to DTC C1419 and C1435 (Click here).
DTC Code
DTC Detection Condition
Trouble Area
C1436
Either condition is met:
  1. With the vehicle stationary, the yaw rate and deceleration sensor output value is not 0°/s.
  2. An abnormal comparison value.
  1. Yaw rate and deceleration sensor
  2. Sensor installation

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (Click here).

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the yaw rate and deceleration sensor, perform calibration (Click here).
  2. Check the yaw rate and deceleration sensor signal after replacement (Click here).


1. CHECK DTC CAN COMMUNICATION SYSTEM
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2. READ VALUE USING INTELLIGENT TESTER (YAW RATE SENSOR)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Yaw Rate Sensor
    Yaw rate and deceleration sensor 1 reading/ Min.: -128°/s, Max.: 127°/s
    Vehicle stationary: 0°/s
    Right turn: -128 to 0°/s
    Left turn: 0 to 127°/s
    -

  1. Check that the yaw rate and deceleration sensor output value is displayed on the tester.

    Result 
    Result
    Proceed to
    NG
    Yaw rate and deceleration sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning
    A
    Yaw rate and deceleration sensor output value is not 0°/s when vehicle is stationary
    B
    OK
    C



B
REPLACE YAW RATE AND DECELERATION SENSOR (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A


3. CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION
  1. Turn the ignition switch off.

  1. Check that the yaw rate and deceleration sensor is installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not installed at an angle.



NG
INSTALL YAW RATE AND DECELERATION SENSOR CORRECTLY (Click here)
OK

REPLACE YAW RATE AND DECELERATION SENSOR (Click here)


← C1436 Yaw Rate Sensor Malfunction (Nov 2010 – Jul 2011)C1436 Yaw Rate Sensor Malfunction (from Aug 2012) →