C1436 Yaw Rate Sensor Malfunction
Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2011
Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
DESCRIPTION
Refer to DTC C1419 and C1435 (Click here).| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1436 |
Either condition is met:
|
|
WIRING DIAGRAM
Refer to DTCs C1232, C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the yaw rate and deceleration sensor, perform calibration (Click here).
- Check the yaw rate and deceleration sensor signal after replacement (Click here).
- When replacing the yaw rate and deceleration sensor, perform calibration (Click here).
| 1. CHECK DTC CAN COMMUNICATION SYSTEM |
Check for DTCs (Click here).
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|
||||
| A | |
| 2. READ VALUE USING INTELLIGENT TESTER (YAW RATE SENSOR) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Yaw Rate Sensor
Yaw rate and deceleration sensor 1 reading/ Min.: -128°/s, Max.: 127°/s
Vehicle stationary: 0°/s
Right turn: -128 to 0°/s
Left turn: 0 to 127°/s
-
Check that the yaw rate and deceleration sensor output value is displayed on the tester.
Result Result
Proceed to
NG
Yaw rate and deceleration sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning
A
Yaw rate and deceleration sensor output value is not 0°/s when vehicle is stationary
B
OK
C
|
|
||||
|
|
||||
| A | |
| 3. CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate and deceleration sensor is installed properly (Click here).
- OK:
- The sensor is tightened to the specified torque.
- The sensor is not installed at an angle.
|
|
||||
| OK | ||
| ||
