2011-2016 FJ Cruiser · Service Manual BRAKE

C1420 Acceleration Sensor Malfunction

Diagnostic trouble codes · Vehicles built Aug 2011 – Jul 2012

Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012

DESCRIPTION

Refer to DTCs C1419 and C1435 (Click here).
DTC Code
DTC Detection Condition
Trouble Area
C1420
After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more.
  1. Sensor installation
  2. Yaw rate and deceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and deceleration sensor, perform calibration (Click here).


1. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING ) (Click here)
A


2. CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION
  1. Check that the yaw rate and deceleration sensor is installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not installed at an angle.



NG
INSTALL YAW RATE AND DECELERATION SENSOR CORRECTLY (Click here)
OK

REPLACE YAW RATE AND DECELERATION SENSOR (Click here)


← C1420 Acceleration Sensor Malfunction (Nov 2010 – Jul 2011)C1420 Acceleration Sensor Malfunction (from Aug 2012) →