C1420 Acceleration Sensor Malfunction
Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2011
Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
DESCRIPTION
Refer to DTCs C1419 and C1435 (Click here).| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1420 |
After the difference between GL1 and GL2 becomes 0.6 G or more with the vehicle stationary, the difference remains 0.4 G or more for 60 seconds or more. |
|
WIRING DIAGRAM
Refer to DTCs C1232, C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the yaw rate and deceleration sensor, perform calibration (Click here).
| 1. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs (Click here).
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|
||||
| A | |
| 2. CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION |
Check that the yaw rate and deceleration sensor is installed properly (Click here).
- OK:
- The sensor is tightened to the specified torque.
- The sensor is not installed at an angle.
|
|
||||
| OK | ||
| ||
