2011-2016 FJ Cruiser · Service Manual BRAKE

C1240 Yaw Rate Sensor Discrimination

Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2012

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

The skid control ECU determines if the yaw rate and deceleration sensor identification information sent via CAN communication matches the yaw rate and deceleration sensor identification information memorized by the skid control ECU.
DTC Code
DTC Detection Condition
Trouble Area
C1240
The yaw rate and deceleration sensor identification information memorized by the skid control ECU does not match the yaw rate and deceleration sensor identification information sent via CAN communication for 1 second or more.
  1. Proper yaw rate and deceleration sensor not installed
  2. Master cylinder solenoid (Skid Control ECU)

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the yaw rate and deceleration sensor, perform calibration (Click here).
  2. When replacing the master cylinder solenoid, perform calibration (Click here).


1. CHECK PART NUMBER (YAW RATE AND DECELERATION SENSOR)
  1. Check that the proper yaw rate and deceleration sensor is installed.

    OK:
    Proper yaw rate and deceleration sensor installed.



NG
REPLACE YAW RATE AND DECELERATION SENSOR (Click here)
OK


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC C1240 output
    A
    DTC not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1232 Acceleration Sensor Stuck Malfunction (+ C1243, C1245, C1279) (from Aug 2012)C1240 Yaw Rate Sensor Discrimination (from Aug 2012) →