CURTAIN SHIELD AIRBAG ASSEMBLY > DISPOSAL |
| 1. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY LH (WHEN INSTALLED IN VEHICLE) |
![]() |
Check the function of SST (Click here).
Precaution (Click here).
Disconnect the cable from the negative battery terminal.
Remove the roof headlining.
Install SST.
![]() |
Disconnect the connector from the curtain shield airbag assembly.
![]() |
Connect the SST connector to the curtain shield airbag assembly.
![]() |
Move SST at least 10 m (33 ft) away from the vehicle side window.
Securing enough clearance for the SST wire harness in the side window, close all doors and windows of the vehicle.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (33 ft) radius of the vehicle.
Press the SST activation switch and deploy the airbag.
| 2. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY LH (WHEN NOT INSTALLED IN VEHICLE) |
![]() |
Check the function of SST (Click here).
Remove the curtain shield airbag assembly (Click here).
![]() |
Cut off the deployment section of the curtain shield airbag assembly.
![]() |
Using a service-purpose wire harness for the vehicle, tie down the curtain shield airbag assembly to the tire.
| Area | Measurement |
| A | 1.25 mm2 or more (0.0019 in.2 or more) |
![]() |
Position the curtain shield airbag assembly inside the tire as shown in the illustration.
| Area | Measurement |
| Width | 185 mm (7.28 in.) |
| Inner diameter | 360 mm (14.17 in.) |
Install SST.
![]() |
Connect the SST connector to the curtain shield airbag assembly.
Place the tires.
![]() |
Place at least 2 tires under the tire to which the curtain shield airbag assembly is tied.
Place at least 2 tires over the tire to which the curtain shield airbag assembly is tied. The top tire should have a disc wheel installed.
![]() |
Tie the tires together with 2 wire harnesses.
Install SST.
![]() |
Connect SST connector.
Move SST at least 10 m (33 ft) away from the airbag tied down to the tires.
Deploy the airbag.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Check that no one is within a 10 m (33 ft) radius of the tire to which the curtain shield airbag assembly is tied.
Press the SST activation switch and deploy the airbag.
![]() |
Dispose of the curtain shield airbag assembly.
Remove the curtain shield airbag assembly from the tire.
Place the curtain shield airbag assembly in a plastic bag, tie it tightly and dispose of it in the same way as other general parts.