SFI SYSTEM > MIL Circuit |

| 1.CHECK THAT MIL IS ILLUMINATED |
Perform troubleshooting in accordance with the chart below.
| Result | Proceed to |
| MIL remains ON | A |
| MIL does not illuminate | B |
|
| ||||
| A | |
| 2.CHECK WHETHER MIL TURNS OFF |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Check whether any DTCs have been stored. Note them down if necessary.
Clear the DTCs (Click here).
Check if the MIL turns off.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the ECM connector.
Turn the ignition switch to ON.
Check that MIL is not illuminated.
| *1 | Rear view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECM) |
Disconnect the ECM connector.
Disconnect the combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E14-7 (CHK) or E78-13 (W) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 5.CHECK THAT MIL IS ILLUMINATED |
Check if the MIL is illuminated when the ignition switch is turned ON.
|
| ||||
| OK | ||
| ||
| 6.CHECK THAT ENGINE STARTS |
Turn the ignition switch to ON.
Start the engine.
| Result | Proceed to |
| Engine starts | A |
| Engine does not start* | B |
|
| ||||
| A | |
| 7.INSPECT COMBINATION METER (MIL CIRCUIT) |
See the combination meter troubleshooting procedure (Click here).
|
| ||||
| OK | ||
| ||