Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
The DTCs are displayed by blinking the SRS warning light.

HINT:
  1. Make sure that DTCs which relate to the CAN communication system are not output. If any of these DTCs are output, check the CAN communication system (Click here).
  2. When a warning light keeps blinking, a short to ground in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
  3. The DTC output mode signal is transmitted through the CAN to an ECU including the center airbag sensor assembly. Thus if no systems enter DTC output mode, the ECM may have a malfunction.


WIRING DIAGRAM


C162321E06


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECM)
C233886E01
  1. Turn the ignition switch off.

  1. Disconnect the connector from the ECM.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-13 (TC) - E77-28 (TC)
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    DLC3
    *b
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS, ECU OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (CG OF DLC3 - BODY GROUND)


    C196989E13
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-4 (CG) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    DLC3



NG
REPAIR OR REPLACE HARNESS, ECU OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (TC CIRCUIT OF ECM)


    C233887E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E77-28 (TC) - Body ground
    Always
    1 MΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS, ECU OR CONNECTOR
OK


4.CHECK DTC
SST
09843-18040  


    C196989E16
  1. Using SST, connect terminals TC and CG of the DLC3.

    NOTICE:
    Connect the terminals to the correct positions to avoid a malfunction.

    Text in Illustration 
    *a
    DLC3
    Result 
    Result
    Proceed to
    DTC output mode is set in each ECU.
    A
    DTC output mode is not set in ECM.
    B
    DTC output mode is not set in center airbag sensor assembly.
    C



B
REPLACE ECM (Click here)

C
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)