Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Reset Switch Circuit

for Preparation Click here


DESCRIPTION

Initialization can be started by pressing the tire pressure warning reset switch and holding it for 3 seconds or more. If the ECU receives the signal from the switch, the tire pressure warning light blinks 3 times (1 second on, 1 second off).

WIRING DIAGRAM


C243849E02


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and note down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.

1.CHECK TIRE PRESSURE WARNING RESET SWITCH FUNCTION
  1. Perform the tire pressure warning reset switch test in Test Mode (Signal Check Mode) Procedure (Click here).

OK:
Reset switch ON:
Tire pressure warning light illuminates.
Reset switch OFF:
Tire pressure warning light blinks.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT TIRE PRESSURE WARNING RESET SWITCH


    C221448E02
  1. Remove the tire pressure warning reset switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON (Switch is pressed and held)
    Below 1 Ω
    OFF (Switch is not pressed)
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Tire Pressure Warning Reset Switch)



NG
REPLACE TIRE PRESSURE WARNING RESET SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SWITCH - TIRE PRESSURE WARNING ECU AND BODY GROUND)
  1. Disconnect the A35 tire pressure warning reset switch connector.

  1. Disconnect the E74 tire pressure warning ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E74-1 (CLSW) - A35-1 (INT)
    Always
    Below 1 Ω
    E74-1 (CLSW) - Body ground
    Always
    10 kΩ or higher
    A35-2 (E)- Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)