Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use the following procedure to troubleshoot the engine immobiliser system.
*: Use a Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
      3. The following 5 items are important points in the problem analysis:


      What
      Vehicle model, system name
      When
      Date, time, occurrence frequency
      Where
      Road conditions
      Under what conditions?
      Driving conditions, weather conditions
      How did it happen?
      Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.CRANK ENGINE FOR MORE THAN 10 SECONDS

      NEXT


      5.CHECK FOR DTCS*
      1. Check for DTCs and note any codes that are output (Click here).

      2. Delete the DTCs (Click here).

      3. Recheck for DTCs. Try to duplicate the DTCs (SFI system and engine immobiliser system) by simulating the symptoms indicated by the DTCs.

        Result:

        Result
        Proceed to
        DTC does not recur
        A
        DTC (SFI system) recurs
        B
        DTC (engine immobiliser system) recurs
        C



      B.
      GO TO DTC CHART (Click here)

      C.
      GO TO DTC CHART (Click here)
      A


      6.READ VALUE USING TECHSTREAM*
      1. Connect a Techstream to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the tester ON.

      4. Enter the following menus: Body Electrical / Immobiliser / Data List.

      5. According to the display on tester, read the "Data List".

        IMMOBILISER: 
        Tester Display
        Measurement Item/Range
        Normal Condition
        Diagnostic Note
        Key SW
        Unlock warning switch signal/ON or OFF
        ON: Key is in ignition key cylinder
        OFF: No key is in ignition key cylinder
        -

        OK:
        ON (Key is in ignition key cylinder) appears on the screen.



      NG.
      GO TO DTC B2780 (Click here).
      OK


      7.PROBLEM SYMPTOMS TABLE

        Result:

        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B



      B.
      GO TO STEP 9
      A


      8.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. DATA LIST / ACTIVE TEST (Click here)

      2. TERMINALS OF ECU (Click here)


      NEXT


      9.ADJUST, REPAIR OR REPLACE

        NEXT


        10.CONFIRMATION TEST

          NEXT

          END