DTC B1630/23 Rear Airbag Sensor RH Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1630/23 |
|
|
| 1.CHECK REAR AIRBAG SENSOR RH |
![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Interchange the rear airbag sensor RH with LH and connect the connectors.
Connect the cable to the negative (-) battery terminal.
Clear the DTCs stored in memory (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B1630/23 is output. | A |
| DTC B1635/24 is output. | B |
| DTCs B1630/23 and B1635/24 are not output. | C |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Return the rear airbag sensor RH and LH to their original positions and connect the connectors.
| *1 | Rear Airbag Sensor LH |
| *2 | Side Airbag Sensor Assembly RH |
|
| ||||
|
| ||||
| A | ||
| ||