Home › ENGINE › 1GR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)
(Click here)


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
(Click here for 2WD)
(Click here for 4WD)


3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)


C135775E01
  1. Align the matchmark on the clutch cover assembly with the one on the flywheel sub-assembly.

  1. Loosen each set bolt one turn at a time until the spring tension is released.

  1. Remove the 6 bolts and clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.



4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc assembly, pressure plate and surface of the flywheel sub-assembly free from oil and foreign matter.



5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


A224775E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A224776
  1. Remove the 8 bolts and flywheel.



6. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


A224775E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A224777
  1. Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear and front drive plate spacer.



7. REMOVE REAR CRANKSHAFT OIL SEAL
  1. Using a knife, cut off the lip of the oil seal.



    A076328E03
  1. Using a screwdriver, pry out the oil seal.
    Text in Illustration 
    *1
    Cut Position

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.

    HINT:
    Tape the screwdriver tip before use.