Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2799    Engine Immobiliser System Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detected errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.

DTC No.
DTC Detection Condition
Trouble Area
B2799
One of following conditions is met:
  1. Error in communication between ECM and transponder key ECU
  2. Error in communication lines
  3. Communication ID is different during communication with transponder key ECU
  1. Wire harness
  2. ECM
  3. Transponder key ECU

WIRING DIAGRAM


B175508E05


INSPECTION PROCEDURE

1.CHECK DTC OUTPUT
  1. Delete the DTC (Click here).

  1. Recheck for DTC.

    OK:
    DTC B2799 output does not reoccur.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.ECU CODE REGISTRATION
  1. Re-register the ECU communication ID between the transponder key ECU and ECM (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Delete the DTC (Click here).

  1. Recheck for DTC.

    OK:
    DTC B2799 output does not reoccur.



NG
Go to step 4
OK

END 

4.CHECK CONNECTION OF CONNECTOR
  1. Turn the ignition switch OFF.

  1. Check that the connectors are properly connected to the ECM and the transponder key ECU.

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTORS PROPERLY
OK


5.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)
  1. Disconnect the E79 ECU and E77 ECM connectors.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      E79-12 (EFII) - E77-20 (IMO)
      Always
      Below 1 Ω
      E79-13 (EFIO) - E77-14 (IMI)
      Always
      Below 1 Ω
      E79-12 (EFII) - Body ground
      Always
      10 kΩ or higher
      E79-13 (EFIO) - Body ground
      Always
      10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


7.ECU CODE REGISTRATION
  1. Re-register the ECU communication ID between the transponder key ECU assembly and ECM (Click here).


NEXT


8.CHECK DTC OUTPUT
  1. Delete the DTC (Click here).

  1. Recheck for DTC.

    OK:
    DTC B2799 output does not reoccur.



NG
REPLACE TRANSPONDER KEY ECU (Click here)
OK

END (ECM IS DEFECTIVE)