Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B279A    Theft Deterrent System Communication Line High Fixation

for Preparation Click here


DESCRIPTION

If the communication line (EFIO-IMI) to the transponder key ECU assembly is stuck high output (e.g. shorted to +B), the ECM stores this DTC.

DTC No.
DTC Detection Condition
Trouble Area
B279A
Communication line (EFIO-IMI) between the ECM and transponder key ECU assembly is stuck high output.
  1. Wire harness or connector
  2. Transponder key ECU assembly
  3. ECM

WIRING DIAGRAM


B203372E24


INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU assembly is replaced, register the key and ECU communication ID (Click here).
  2. If the ECM is replaced, register the ECU communication ID (Click here).

1.CHECK DTC OUTPUT
  1. Recheck for DTCs (Click here).

    HINT:
    If any DTCs other than DTC B279A are output, troubleshoot those DTCs first.

    Result 
    Result
    Proceed to
    DTC B279A is output
    A
    DTC B279A and other DTCs are output
    B



B
GO TO DTC CHART (Click here)
A


2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)
  1. Disconnect the transponder key ECU assembly connector.



    B242540E01
  1. Disconnect the ECM connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E79-13 (EFIO) - E77-14 (IMI)
    Always
    Below 1 Ω
    E79-13 (EFIO) - Body ground
    Always
    10 kΩ or higher
    E77-14 (IMI) - Body ground
    Always
    10 kΩ or higher

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E79-13 (EFIO) - Body ground
    Always
    Below 1 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Transponder Key ECU Assembly)
    *2
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK TRANSPONDER KEY ECU ASSEMBLY (OUTPUT)
  1. Reconnect the transponder key ECU assembly connector.

  1. Reconnect the ECM connector.



    B242908E01
  1. Using an oscilloscope, check the waveform.
    Waveform 1 (Reference) 
    Item
    Content
    Terminal No. (Symbols)
    E79-13 (EFIO) - E79-16 (GND)
    Tool Setting
    5 V/DIV., 50 ms./DIV.
    Condition
    Ignition switch ON
    Text in Illustration 
    *1
    Component with harness connected
    (Transponder Key ECU Assembly)



NG
REPLACE ECM (Click here)
OK


4.REPLACE TRANSPONDER KEY ECU ASSEMBLY
  1. Replace the transponder key ECU assembly (Click here).


NEXT


5.REGISTER KEY
  1. Register the key (Click here).


NEXT


6.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Click here).


NEXT


7.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    OK:
    DTC B279A is not output.



NG
REPLACE ECM (Click here)
OK

END (TRANSPONDER KEY ECU WAS DEFECTIVE)