2014-2019 Hiace · Service Manual BRAKE

C120B IG Supply Voltage Low

Diagnostic trouble codes · Vehicles built from Dec 2017

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
C120B
Master cylinder pressure sensor power supply voltage decrease occurs or history of voltage decrease exists, and defective master cylinder pressure sensor output continues for 1 second or more.
  1. Master cylinder pressure sensor output defective
  2. Skid control ECU (Brake actuator assembly)
  3. ABS SOL fuse

WIRING DIAGRAM

Refer to DTC C1241 (Click here).

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following procedure.


1. CHECK HARNESS AND CONNECTOR (+BS TERMINAL)
C306843E01
  1. Turn the ignition switch off.

  1. Make sure that there is no looseness at the locking part and the connecting part of the connector.

  1. Disconnect the B92 skid control ECU (brake actuator assembly) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    B92-38 (+BS) - Body ground
    Always
    11 to 14 V
    B92-38 (+BS) - B92-25 (GND1)
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU (Brake Actuator Assembly))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (+BS CIRCUIT)
OK


2. RECONFIRM DTC
  1. Reconnect the B92 skid control ECU (brake actuator assembly) connector.

  1. Clear the DTCs (Click here).

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC C120B is not output
    A
    DTC C120B is output
    B



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C120B IG Supply Voltage Low (Jan 2017 – Nov 2017)C1210 Zero Point Calibration of Yaw Rate Sensor Undone (+ C1336) (Jan 2015 – Mar 2016) →