C120B IG Supply Voltage Low
Diagnostic trouble codes · Vehicles built Apr 2016 – Dec 2016
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C120B |
Master cylinder pressure sensor power supply voltage decrease occurs or history of voltage decrease exists, and defective master cylinder pressure sensor output continues for 1 second or more. |
|
WIRING DIAGRAM
Refer to DTC C1241 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).
- Inspect the fuses for circuits related to this system before performing the following procedure.
- When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).
| 1. CHECK HARNESS AND CONNECTOR (+BS TERMINAL) |
![]() ![]() |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the B92 skid control ECU (brake actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
B92-38 (+BS) - Body ground
Always
11 to 14 V
B92-38 (+BS) - B92-25 (GND1)
Always
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Reconnect the B92 skid control ECU (brake actuator assembly) connector.
Clear the DTCs (Click here).
Check if the same DTC is recorded (Click here).
- Result:
Result
Proceed to
DTC C120B is not output
A
DTC C120B is output
B
|
|
||||
| A | ||
| ||


