REMOVAL
Removal / installation · Vehicles built from Oct 2014
| 1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission) |
| 2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission) |
| 3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission) |
Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

Loosen each set bolt one turn at a time until spring tension is released.
Remove the set bolts, and pull off the clutch cover assembly.
- NOTICE:
- Do not drop the clutch disc assembly.
| 4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission) |
- NOTICE:
- Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.
| 5. REMOVE FLYWHEEL SUB-ASSEMBLY |
Fix the crankshaft with SST.

- SST
- 09213-58013
09330-00021
For manual transmission.

Remove the 8 bolts and flywheel.
For automatic transmission.
Remove the 8 bolts, and remove the drive plate spacer rear, drive plate and flywheel.
| 6. REMOVE REAR END PLATE |
Remove the bolt and rear end plate.
| 7. REMOVE ENGINE REAR OIL SEAL RETAINER |
Remove the 7 bolts and engine rear oil seal retainer.

| 8. REMOVE ENGINE REAR OIL SEAL |
Remove the oil seal with a slotted screwdriver in the manner shown in the illustration.

- HINT:
- Put a protection material around its sharp end of the screwdriver to protect the oil seal retainer.
Remove oil seal packing (FIPG) from the engine rear oil seal retainer.
