2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL FUEL SENDER GAUGE ASSEMBLY
  1. Install the fuel hose grommet to the fuel tank assembly.

  1. Install a new fuel suction tube set gasket, fuel pump gauge retainer and fuel sender gauge assembly with the 8 bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Install the fuel tank wire, fuel evaporation No.1 tube sub-assembly, fuel tank main tube sub-assembly and fuel tank return tube sub-assembly to the fuel sender gauge assembly.


2. INSTALL FUEL TANK ASSEMBLY

  1. A102475J06
    Using the transmission jack, install the 2 fuel tank band sub-assemblies and fuel tank assembly with the 6 bolts.

    Torque:
    45 N*m{ 459 kgf*cm , 32 ft.*lbf }

  1. Connect the parking brake cable No.3 with the blot.

    Torque:
    15 N*m{ 148 kgf*cm , 11 ft.*lbf }


3. CONNECT FUEL HOSE NO.3

  1. A102472J09
    Connect the fuel hose No.3, and tighten the clamp bolt.


4. INSTALL FUEL HOSE PROTECTOR

  1. A309405
    Install the fuel hose protector to the fuel tank to filler pipe hose and attach the 2 claws.


5. CONNECT FUEL TANK BREATHER TUBE

  1. A102474J06
    Connect the fuel tank breather tube and clip.


6. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A102470J04
    Connect the fuel tank main tube sub-assembly with the clip.


7. CONNECT FUEL TANK RETURN TUBE SUB-ASSEMBLY

  1. A102468J06
    Connect the fuel return tube sub-assembly. (Click here)


8. CONNECT FUEL TANK WIRE

  1. A102471E03
    Connect the fuel tank wire.


9. INSTALL PROPELLER SHAFT ASSEMBLY

HINT:
  1. Propeller shaft assembly for Super Long Wheelbase (Click here)
  2. Propeller shaft assembly for Long Wheelbase (Click here)


10. CHECK FOR FUEL LEAKS
  1. PERFORM ACTIVE TEST

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch on.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Active Test.

    5. Perform the Active Test.

      Tester Display
      Test Details
      Control Range
      Diagnostic Notes
      Test the Fuel Leak
      Pressurizes common rail internal fuel pressure, and checks for fuel leaks
      Stop/Start
      1. Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when ON is selected
      2. Above conditions preserved while test is ON

← REMOVAL (from Oct 2014)INSPECTION (from Oct 2014) →