HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Jan 2015 – Mar 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
- HINT:
- Use the following procedure to troubleshoot the lighting system.
- *: Use the GTS.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
| 3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the GTS to check if the CAN communication system is functioning normally (Click here).
Result
Result
|
Proceed to
|
DTC is not output
|
A
|
DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Check for DTCs (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
Result
Result
|
Proceed to
|
DTC output does not reoccur
|
A
|
DTC output reoccurs
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Refer to Problem Symptoms Table (Click here).
Result
Result
|
Proceed to
|
Fault is not listed in Problem Symptoms Table
|
A
|
Fault is listed in Problem Symptoms Table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (Click here)
Terminals of ECU (Click here)
Fail-safe Chart (Click here)
Data List / Active Test (Click here)
| NEXT |
|
 |
|
|
| 7.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|