2014-2019 Hiace · Service Manual SECURITIES

B2790 ID BOX EEPROM Malfunction

Diagnostic trouble codes · Vehicles built from Oct 2014

DESCRIPTION

When an internal malfunction occurs in the ID code box (immobiliser code ECU), the certification ECU (smart key ECU assembly) stores this DTC.
DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B2790
An internal malfunction occurs in the ID code box (immobiliser code ECU) (EEPROM access malfunction) (1 trip detection logic*1).
  1. ID code box (immobiliser code ECU)
  2. Certification ECU (smart key ECU assembly)
An immobiliser set/unset operation is performed (the engine switch is turned off or on (IG) while the electrical key transmitter sub-assembly is being carried).
  1. *1: Only output while a malfunction is present.
Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
  1. Engine running: Engine cannot be started next time
  2. Engine stopped: Engine cannot be started
-
Related Data List and Active Test 
DTC Code
Data List and Active Test
B2790
-

INSPECTION PROCEDURE

NOTICE:
  1. When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry & Start (CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
  2. Before replacing the certification ECU (smart key ECU assembly) or ID code box (immobiliser code ECU), refer to Service Bulletin.
  3. After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."


1. REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
  1. Replace the ID code box (immobiliser code ECU) with a new one.

    HINT:
    Refer to the Service Bulletin.


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. REGISTER RECOGNITION CODES
  1. Register the recognition codes in the ECUs.

    HINT:
    Refer to the Service Bulletin.


NEXT


4. REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID.

    HINT:
    Refer to the Service Bulletin.


NEXT


5. CHECK FOR DTC
  1. Check for DTCs (Click here).

    HINT:
    Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

    OK:
    DTC B2790 is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (ID CODE BOX [IMMOBILISER CODE ECU] WAS DEFECTIVE)


← B278A Short to GND in Immobiliser System Power Source Circuit (from Apr 2016)B2799 Engine Immobiliser System Malfunction (Oct 2014 – Dec 2014) →