2014-2019 Hiace · Service Manual ENGINE

P1225 Spill Control Circuit

Diagnostic trouble codes · Vehicles built from Oct 2014

DESCRIPTION

The ECM controls the fuel injection volume by operating the spill control valve. The spill control valve is mounted on the injection or supply pump assembly, and opens or closes the injection pressure releasing port with the solenoid valve in the spill control valve. During injection, the valve is closed (ON). The ECM decides the basic fuel injection volume by the engine speed and accelerator pedal opening angle, and calculates the final fuel injection angle to make the various corrections to the basic fuel injection volume. The ECM counts the NE signal to detect the angle from injection starts and operates the spill control valve from ON to OFF (the injection pressure releasing port is open) at the position that detects the final fuel injection angle.
A076134E02
DTC No.
DTC Detection Condition
Trouble Area
P1225
Open or short in spill control valve at 500 rpm or more.
  1. Open or short in spill control valve circuit
  2. Spill control valve (Injection or supply pump assembly)
  3. ECM

WIRING DIAGRAM

A311406E02

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. INSPECT SPILL CONTROL VALVE

  1. A105094E01
    Disconnect the spill control valve connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Specified Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    1 to 2 Ω

    HINT:
    The spill control valve is integrated with the injection or supply pump assembly. If the spill control valve is replaced, the injection or supply pump assembly must be replaced in whole.



NG
REPLACE INJECTION OR SUPPLY PUMP ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (ECM - SPILL CONTROL VALVE)
  1. Disconnect the spill control valve connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D59-2 - D100-82 (SPV+)
    Always
    Below 1 Ω
    D59-1 - D100-41 (SPV-)
    Always
    Below 1 Ω
    D59-2 or D100-82 (SPV+) - Body ground
    Always
    10 kΩ or higher
    D59-1 or D100-41 (SPV-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← P1222 Throttle Motor Circuit Range/Performance (from Oct 2014)P1290 Radiator / Engine Coolant Temperature Circuit (from Oct 2014) →