2014-2019 Hiace · Service Manual ENGINE

P1290 Radiator / Engine Coolant Temperature Circuit

Diagnostic trouble codes · Vehicles built from Oct 2014

DESCRIPTION

The radiator side engine coolant temperature sensor senses the coolant temperature. A thermistor built into the sensor changes the resistance value according to the coolant temperature. The lower the coolant temperature, the greater the thermistor resistance value, and the higher the coolant temperature, the lower the thermistor resistance value (See Fig. 1). The radiator side engine coolant temperature sensor is connected to the ECM. The 5 V power source voltage in the ECM is applied to the radiator side engine coolant temperature sensor from the terminal RTHW via a resistor R. That is, the resistor R and the radiator side engine coolant temperature sensor are connected in series. When the resistance value of the radiator side engine coolant temperature sensor changes in accordance with changes in the coolant temperature, the potential at the terminal RTHW also changes. Based on this signal, the ECM increases the fuel injection volume to improve driveability during cold engine operation.
The radiator side engine coolant temperature sensor controls the radiator fan.
A071307E01
DTC No.
DTC Detection Condition
Trouble Area
P1290
Open or short in radiator side engine coolant temperature sensor circuit for 3 second or more.
  1. Open or short in radiator side engine coolant temperature sensor circuit
  2. Radiator side engine coolant temperature sensor
  3. ECM

WIRING DIAGRAM

A311404E12

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. INSPECT RADIATOR SIDE ENGINE COOLANT TEMPERATURE SENSOR

  1. A105095E06
    Measure the resistance according to the illustration.

    OK:
    The resistance value is within the acceptable range shown in the illustration.

    NOTICE:
    If checking the radiator side engine coolant temperature sensor in the water, do not allow water to enter the terminals, and after checking, wipe off the sensor.



NG
REPLACE RADIATOR SIDE ENGINE COOLANT TEMPERATURE SENSOR
OK


2. CHECK HARNESS AND CONNECTOR (ECM - RADIATOR SIDE ENGINE COOLANT TEMPERATURE SENSOR)
  1. Disconnect the radiator side engine coolant temperature sensor connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B29-2 - D100-68 (RTHW)
    Always
    Below 1 Ω
    B29-1 - D100-91 (EPEX)
    Always
    Below 1 Ω
    B29-2 or D100-68 (RTHW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← P1225 Spill Control Circuit (from Oct 2014)P1520 Stop Light Switch Circuit (from Oct 2014) →