2014-2019 Hiace · Service Manual BRAKE

FREEZE FRAME DATA

Troubleshooting · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017


FREEZE FRAME DATA
  1. Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
    The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from off to the ON position since the last time the ABS was activated.

    HINT:
    1. However, if the vehicle is stopped or at low speed (4.3 mph (7 km/h) or less), or if a DTC is detected, the skid control ECU will stop counting.
    2. Freeze frame data at the time the ABS operates:
      The skid control ECU stores and updates data whenever the ABS system operates.
      When the ECU stores data at the time a DTC is detected, the data stored during ABS operation is erased.
    3. Freeze frame data at the time a DTC is detected:
      When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.

  2. Connect the intelligent tester to the DLC3.

  3. Turn the ignition switch to the ON position.

  4. On the tester display, select the FREEZE FRAME DATA.

    Intelligent Tester Display
    Measurement Item
    Reference Value
    Vehicle Speed
    Vehicle speed reading
    Min.: 0 mph (0 km/h), Max.: 202 mph (326.4 km/h)
    Stop Light SW
    Stop light switch signal
    Stop light switch ON: ON, OFF: OFF
    Number of IG ON
    Number of operations of ignition switch ON after memorizing freeze frame data
    0 to 31
    Operated System
    System status
    ABS activated: ABS
    No system activated: NO SYS
    Freeze DTC
    Freeze DTC (Trouble code)
    -
    Vehicle Speed Grade
    Vehicle speed change
    Min: -1.869 G, Max.: 1.869 G

← DTC CHECK / CLEAR (from Jan 2017)FREEZE FRAME DATA (Jan 2015 – Dec 2016) →