2014-2019 Hiace · Service Manual BRAKE

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

HINT:
  1. The vehicle stability control system troubleshooting procedures are based on the premise that the CAN communication system is functioning normally. Check the CAN communication system first before troubleshooting the vehicle stability control system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer and confirm the trouble (Click here).

    NEXT

    3.CHECK DTC AND FREEZE FRAME DATA*
    1. Check and record DTC and Freeze Frame Data (Click here for DTC Check/Clear, and Click here for Freeze Frame Data).

    2. Clear the DTC and Freeze Frame Data (Click here for DTC Check/Clear, and Click here for Freeze Frame Data).

    3. Reconfirm the DTC.

      1. Reconfirm the DTC based on the recorded DTC and Freeze Frame Data (Click here for DTC Check/Clear, and Click here for Freeze Frame Data).

        HINT:
        1. If DTC U0100, U0124 or U0126 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit (Click here).
        2. If there is no response from the skid control ECU (brake actuator assembly), inspect the +BS circuit of the skid control ECU (brake actuator assembly) (Click here).


        Result:
        Result
        Proceed to
        DTC is output
        A
        DTC is not output (Problem symptom does not occur)
        B
        DTC is not output (Problem symptom occurs)
        C


    B.

    C.
    A

    4.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).

    NEXT

    5.SYMPTOM SIMULATION
    1. Proceed to Check for Intermittent Problems (Click here).

    NEXT

    6.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).

    NEXT

    7.CIRCUIT INSPECTION*
      NEXT

      8.IDENTIFICATION OF PROBLEM
        NEXT

        9.REPAIR OR REPLACE
          NEXT

          10.CONFIRMATION TEST*
            NEXT

            ← HOW TO PROCEED WITH TROUBLESHOOTING (Jan 2015 – Mar 2016)HOW TO PROCEED WITH TROUBLESHOOTING (Jan 2017 – Nov 2017) →