C1337/37 Diameter of the Tire is not Uniform
Diagnostic trouble codes · Vehicles built Oct 2014 – Dec 2014
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017
DESCRIPTION
The skid control ECU measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing that all 4 wheels are operating properly. Therefore, all wheel signals must be equal.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C1337/37 |
The speed of one or more of the wheels differs from vehicle speed for 60 seconds or more while driving at 19 mph (30 km/h) or more. |
|
INSPECTION PROCEDURE
| 1. CHECK TIRE SIZE |
Check the size and condition of all 4 tires.
|
|
||||
| OK | |
| 2. INSPECT SKID CONTROL ROTOR |
Check the rotor (Click here for front, or Click here for rear).
- NOTICE:
- Check the speed sensor signal after cleaning or replacement (Click here).
|
|
||||
| OK | |
| 3. INSPECT SPEED SENSOR |
Check the speed sensor and sensor tip (Click here for front, or Click here for rear).
- NOTICE:
- Check the speed sensor signal after cleaning or replacement (Click here).
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND SPEED SENSOR) |
Check the speed sensor circuit (Click here for front, or Click here for rear).
|
|
||||
| OK | |
| 5. RECONFIRM DTC |
Clear the DTCs (Click here).
Drive the vehicle at a speed of approximately 19 mph (30 km/h) or more for 60 seconds or more.
Check that the same DTC is recorded (Click here).
- HINT:
- Reinstall the sensors, connectors, etc. and restore the vehicle to its prior condition before rechecking for DTCs.
- Result:
Condition
Proceed to
DTC (C1337/37) is output
A
DTC (C1337/37) is not output
B
|
|
||||
| A | ||
| ||
