Illumination Circuit
Circuit diagnosis · Vehicles built Oct 2014 – Dec 2014
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
Power is supplied to the radio receiver assembly and steering pad switch LH illumination when the headlight dimmer switch assembly is in the tail or head position.WIRING DIAGRAM


INSPECTION PROCEDURE
- CAUTION:
- The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precautionary notice for the SRS (Click here).
| 1. CHECK ILLUMINATION |
Check if the illumination for the radio receiver assembly, steering pad switch LH, glove box or other parts (hazard switch, transmission control switch, etc.) comes on when the light control switch is turned to the tail or head position.
Result Result
Proceed to
Illumination comes on for all components except steering pad switch LH
A
Illumination comes on for all components except radio receiver assembly.
B
No illumination comes on (radio receiver assembly, hazard switch, glove box, etc.).
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - BATTERY) |
Disconnect the spiral cable sub-assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
H77-13 (IL2+) - Body ground
Headlight dimmer switch assembly tail or head
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Spiral Cable Sub-assembly)
|
|
||||
| OK | |
| 3. INSPECT STEERING PAD SWITCH LH |
Remove the steering pad switch LH (Click here).
Inspect the steering pad switch LH (Click here).
|
|
||||
| OK | |
| 4. INSPECT SPIRAL CABLE SUB-ASSEMBLY |
Remove the spiral cable sub-assembly (Click here).
Inspect the spiral cable sub-assembly (Click here).
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY) |
Disconnect the I2 radio receiver assembly connector.
Disconnect the H77 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
I2-9 (SWG) - H77-3 (EAU)
Always
Below 1 Ω
I2-9 (SWG) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
| 6. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the radio receiver assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
I2-7 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
I2-10 (ILL+) - Body ground
Headlight dimmer switch assembly tail or head
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Radio Receiver Assembly)
|
|
||||
| OK | ||
| ||
