Brake Warning Light does not Come ON
Circuit diagnosis · Vehicles built Apr 2016 – Dec 2016
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
Refer to Brake Warning Light Remains ON (Click here).WIRING DIAGRAM
Refer to Brake Warning Light Remains ON (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
- Result:
Result
Proceed to
DTC is not output
A
DTC is output
B
|
|
||||
| A | |
| 2. PERFORM ACTIVE TEST USING GTS (BRAKE WARNING LIGHT) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the GTS, perform the Active Test.
ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
Brake Warning Light
Brake warning light
Warning light OFF/ON
Observe combination meter assembly
Vehicle condition: Vehicle stopped
When performing the Brake Warning Light Active Test, check Brake Warning Light in the Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Brake Warning Light
Brake warning light / ON or OFF
ON: Warning light on
OFF: Warning light off
-
- Result:
Result
Proceed to
Brake warning light in the Data List turns ON/OFF using the Active Test
A
Brake warning light in the Data List does not change using the Active Test
B
|
|
||||
| A | |
| 3. INSPECT COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Perform Active Test of the combination meter assembly using the GTS (Click here).
Check the combination meter assembly.
- OK:
- The brake warning light turns on or off in accordance with the GTS.
|
|
||||
| OK | ||
| ||
