2014-2019 Hiace · Service Manual BRAKE

Brake Warning Light does not Come ON

Circuit diagnosis · Vehicles built Jan 2015 – Mar 2016

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

Refer to Brake Warning Light Remains ON (Click here).

WIRING DIAGRAM

Refer to Brake Warning Light Remains ON (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
CHECK CAN COMMUNICATION SYSTEM (Click here)
A


2. PERFORM ACTIVE TEST USING GTS (BRAKE WARNING LIGHT)
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

  1. According to the display on the GTS, perform the Active Test.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Brake Warning Light
    Brake warning light
    Warning light OFF/ON
    Observe combination meter assembly
    Vehicle condition: Vehicle stopped

  1. When performing the Brake Warning Light Active Test, check Brake Warning Light in the Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Brake Warning Light
    Brake warning light / ON or OFF
    ON: Warning light on
    OFF: Warning light off
    -

    Result:
    Result
    Proceed to
    Brake warning light in the Data List turns ON/OFF using the Active Test
    A
    Brake warning light in the Data List does not change using the Active Test
    B



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A


3. INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Perform Active Test of the combination meter assembly using the GTS (Click here).

  1. Check the combination meter assembly.

    OK:
    The brake warning light turns on or off in accordance with the GTS.



NG
INSPECT METER / GAUGE SYSTEM (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← Brake Warning Light Remains ON (from Dec 2017)Brake Warning Light does not Come ON (Apr 2016 – Dec 2016) →