Brake Warning Light does not Come ON
Circuit diagnosis · Vehicles built from Dec 2017
Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
Refer to Brake Warning Light Remains ON (Click here).WIRING DIAGRAM
Refer to Brake Warning Light Remains ON (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
 |
|
B |
 |
|
|
|
| A |
|
 |
|
| 2. PERFORM ACTIVE TEST USING GTS (BRAKE WARNING LIGHT) |
 |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the GTS, perform the Active Test.
ABS/VSC/TRC
Tester Display
|
Test Part
|
Control Range
|
Diagnostic Note
|
Brake Warning Light
|
Brake warning light
|
Warning light OFF/ON
|
Observe combination meter assembly Vehicle condition: Vehicle stopped
|
When performing the Brake Warning Light Active Test, check Brake Warning Light in the Data List.
ABS/VSC/TRC
Tester Display
|
Measurement Item/Range
|
Normal Condition
|
Diagnostic Note
|
Brake Warning Light
|
Brake warning light / ON or OFF
|
ON: Warning light on OFF: Warning light off
|
-
|
- Result:
Result
|
Proceed to
|
Brake warning light in the Data List turns ON/OFF using the Active Test
|
A
|
Brake warning light in the Data List does not change using the Active Test
|
B
|
|
B |
 |
|
|
|
| A |
|
 |
|
| 3. INSPECT COMBINATION METER ASSEMBLY |
 |
Turn the ignition switch off.
Perform Active Test of the combination meter assembly using the GTS (Click here).
Check the combination meter assembly.
- OK:
- The brake warning light turns on or off in accordance with the GTS.
|
NG |
 |
|
|
|
| OK |
|
 |
|
|