VC Output Circuit
Circuit diagnosis · Vehicles built Jan 2015 – Mar 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
The VC voltage (5 V) is generated in the ECM. The voltage is used to supply power to the throttle position sensor, manifold absolute pressure sensor, accelerator position sensor and fuel pressure sensor.WIRING DIAGRAM




INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
| 1. CHECK MIL |
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch ON.
Result Condition
Proceed to
MIL does not illuminate
A
MIL illuminates
B
|
|
||||
| A | |
| 2. CHECK CONNECTION BETWEEN GTS AND ECM |
Connect the GTS to the DLC3.
Turn the ignition switch ON and GTS ON.
Check the communication between the GTS and ECM.
- Result:
Condition
Proceed to
Communication is not possible
A
Communication is possible
B
|
|
||||
| A | |
| 3. CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the throttle position sensor connector.
Turn the ignition switch ON.
Check the MIL.
- Result:
Condition
Proceed to
MIL does not illuminate
A
MIL illuminates
B
Reconnect the throttle position sensor connector.
|
|
||||
| A | |
| 4. CHECK MIL (MANIFOLD ABSOLUTE PRESSURE SENSOR) |
Disconnect the manifold absolute pressure sensor connector.
Turn the ignition switch ON.
Check the MIL.
- Result:
Condition
Proceed to
MIL does not illuminate
A
MIL illuminates
B
Reconnect the manifold absolute pressure sensor connector.
|
|
||||
| A | |
| 5. CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR) |
Disconnect the accelerator pedal position sensor connector.
Turn the ignition switch ON.
Check the MIL.
- Result:
Condition
Proceed to
MIL does not illuminate
A
MIL illuminates
B
Reconnect the accelerator position sensor connector.
|
|
||||
| A | |
| 6. CHECK MIL (FUEL PRESSURE SENSOR) |
Disconnect the fuel pressure sensor connector.
Turn the ignition switch ON.
Check the MIL.
- Result:
Condition
Proceed to
MIL does not illuminate
A
MIL illuminates
B
Reconnect the fuel pressure sensor connector.
|
|
||||
| A | |
| 7. CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND) |
Disconnect the throttle position sensor connector.
Disconnect the manifold absolute pressure sensor connector.
Disconnect the fuel pressure sensor connector.
Disconnect the accelerator pedal position sensor connector.
Disconnect the ECM connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
D105-97 (VCVL) - Body ground
Always
10 kΩ or higher
D105-93 (VCPM) - Body ground
Always
10 kΩ or higher
D105-68 (VCS) - Body ground
Always
10 kΩ or higher
B88-55 (VCPA) - Body ground
Always
10 kΩ or higher
B88-58 (VCP2) - Body ground
Always
10 kΩ or higher
Reconnect the throttle position sensor connector.
Reconnect the manifold absolute pressure sensor connector.
Reconnect the fuel pressure sensor connector.
Reconnect the accelerator pedal position sensor connector.
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||
