2014-2019 Hiace · Service Manual TRANSMISSION

REPLACEMENT

Removal / installation · Vehicles built Oct 2014 – Dec 2014


1. DRAIN AUTOMATIC TRANSMISSION FLUID

  1. C295041
    Remove the drain plug and gasket, and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }


2. REMOVE PROPELLER SHAFT ASSEMBLY
(Click here)

3. REMOVE EXTENSION HOUSING REAR OIL SEAL

  1. D028697E01
    Using SST, remove the extension housing rear oil seal together with the dust seal and retainer.
    SST
    09308-10010  


4. INSTALL EXTENSION HOUSING REAR OIL SEAL
  1. Coat the lip of a new extension housing rear oil seal with MP grease.

  1. C295038E01
    Using SST and a hammer, tap in the extension housing rear oil seal.
    SST
    09309-37010  

    Standard depth:
    6.2 to 6.8 mm (0.245 to 0.267 in.)

    NOTICE:
    Be careful not to damage the lip of the extension housing rear oil seal.

  1. Install a new dust seal to a new retainer.

  1. C295039E01
    Using SST and a hammer, tap in the dust seal together with the retainer.
    SST
    09309-37010  

    Standard distance:
    0.7 to 1.3 mm (0.0276 to 0.0511 in.)


5. INSTALL PROPELLER SHAFT ASSEMBLY
(Click here)

6. ADD AUTOMATIC TRANSMISSION FLUID

Fluid type:
Toyota Genuine ATF Type T-IV


7. CHECK AUTOMATIC TRANSMISSION FLUID LEVEL
(Click here)
← COMPONENTS (Oct 2014 – Dec 2014)COMPONENTS (Oct 2014 – Dec 2014) →