2014-2019 Hiace · Service Manual RESTRAINTS

B1610/13 Front Airbag Sensor RH Malfunction

Diagnostic trouble codes · Vehicles built Jan 2015 – Mar 2016

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

DESCRIPTION

The front airbag sensor RH consists of a diagnostic circuit and frontal deceleration sensor, etc.
If the center airbag sensor assembly receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.
DTC B1610/13 is stored when a malfunction is detected in the front airbag sensor RH circuit.
DTC Code
DTC Detection Condition
Trouble Area
B1610/13
Either condition is met:
  1. A front airbag sensor RH malfunction.
  2. A center airbag sensor assembly malfunction.
  1. Front airbag sensor RH
  2. Center airbag sensor assembly

WIRING DIAGRAM

C279108E06
C279108E07

INSPECTION PROCEDURE

NOTICE:
  1. When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Click here).
  2. After replacing the center airbag sensor assembly, refer to initialization (Click here).


1. CHECK FRONT AIRBAG SENSOR RH
C171014E01
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Interchange the front airbag sensor RH with LH and connect the connectors to them.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear the DTCs stored in memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC B1610 is output
    A
    DTC B1615 is output
    B
    DTC B1610 and B1615 are not output
    C

    HINT:
    Codes other than DTC B1610 and B1615 may be output at this time, but they are not related to this check.

    Text in Illustration 
    *1
    Front Airbag Sensor LH
    *2
    Center Airbag Sensor Assembly

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Return the front airbag sensor LH and RH to their original positions and connect the connectors to them.



A
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)

B
REPLACE FRONT AIRBAG SENSOR RH (Click here)
C

USE SIMULATION METHOD TO CHECK (Click here)


← B1610/13 Front Airbag Sensor RH Circuit Malfunction (Oct 2014 – Dec 2014)B1610/13 Front Airbag Sensor RH Malfunction (Apr 2016 – Dec 2016) →