B2785 Communication Malfunction between ECUs Connected by LIN
Diagnostic trouble codes · Vehicles built from Jan 2015
Versions by build date: Oct 2014 – Dec 2014 from Jan 2015
DESCRIPTION
The certification ECU (smart key ECU assembly) monitors the LIN communication bus between the components related to the certification intermittently. DTC B2785 is output when a malfunction in the LIN communication bus between the components related to the certification is detected continuously 3 times.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2785 |
Certification ECU (smart key ECU assembly) detects malfunction in LIN communication bus between components related to certification continuously 3 times |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When using the GTS with the engine switch off to troubleshoot:
Connect the GTS to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the GTS and vehicle begins.
- Before replacing the certification ECU (smart key ECU assembly), refer to the smart entry and start system (for Entry Function) (Click here).
- When using the GTS with the engine switch off to troubleshoot:
| 1. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Check for DTCs (Click here).
Result Result
Proceed to
DTC B2785 is output
A
DTC B2785 is not output
B
|
|
||||
| A | |
| 3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - ID CODE BOX [IMMOBILISER CODE ECU] OR STEERING LOCK ACTUATOR ASSEMBLY) |
Disconnect the B75 certification ECU (smart key ECU assembly) connector.
Disconnect the H81 ID code box (immobiliser code ECU) connector.
Disconnect the H80 steering lock actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
B75-5 (LIN) - H80-5 (LIN)
Always
Below 1 Ω
B75-5 (LIN) - H81-2 (LIN1)
Always
Below 1 Ω
B75-5 (LIN) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. CLEAR DTC |
Disconnect the H80 steering lock actuator assembly connector.
Clear the DTCs (Click here).
| NEXT | |
| 5. CHECK FOR DTC |
Check for DTCs (Click here).
Result Result
Proceed to
DTC B2785 is output
A
DTC B2785 is not output
B
|
|
||||
| A | |
| 6. CLEAR DTC |
Disconnect the H81 ID code box (immobiliser code ECU) connector.
Clear the DTCs (Click here).
| NEXT | |
| 7. CHECK FOR DTC |
Check for DTCs (Click here).
Result Result
Proceed to
DTC B2785 is output
A
DTC B2785 is not output
B
|
|
||||
| A | ||
| ||
