2014-2019 Hiace · Service Manual BODY ELECTRICAL

Hazard Warning Switch Circuit

Circuit diagnosis · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

DESCRIPTION

The combination meter receives hazard warning signal switch information signals and illuminates the hazard warning light(s).

WIRING DIAGRAM

E290809E01

INSPECTION PROCEDURE


1. READ VALUE USING GTS (HAZARD WARNING SIGNAL SWITCH)
  1. Using the GTS, read the Data List (Click here).

Combination Meter 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Hazard Flasher Switch
Hazard warning signal switch signal / ON or OFF
ON: Hazard warning signal switch on
OFF: Hazard warning signal switch off
-

OK:
Normal conditions listed above are displayed.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT HAZARD WARNING SIGNAL SWITCH
  1. Remove the hazard warning signal switch (Click here).

  1. Inspect the hazard warning signal switch (Click here).



NG
REPLACE HAZARD WARNING SIGNAL SWITCH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH - COMBINATION METER AND BODY GROUND)
  1. Disconnect the H9 hazard warning signal switch connector.

  1. Disconnect the H20 combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H9-3 - H20-28 (HAZ)
    Always
    Below 1 Ω
    H9-4 - Body ground
    Always
    Below 1 Ω
    H9-3 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Turn Signal Switch Circuit (from Jan 2017)Hazard Warning Switch Circuit (Jan 2015 – Mar 2016) →