Hazard Warning Switch Circuit
Circuit diagnosis · Vehicles built Apr 2016 – Dec 2016
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
The combination meter receives hazard warning signal switch information signals and illuminates the hazard warning light(s).WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING GTS (HAZARD WARNING SIGNAL SWITCH) |
Using the GTS, read the Data List (Click here).
| Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
| Hazard Flasher Switch |
Hazard warning signal switch signal / ON or OFF |
ON: Hazard warning signal switch on OFF: Hazard warning signal switch off |
- |
- OK:
- Normal conditions listed above are displayed.
|
|
||||
| OK | ||
| ||
| 2. INSPECT HAZARD WARNING SIGNAL SWITCH |
Remove the hazard warning signal switch (Click here).
Inspect the hazard warning signal switch (Click here).
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH - COMBINATION METER AND BODY GROUND) |
Disconnect the H9 hazard warning signal switch connector.
Disconnect the H20 combination meter connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H9-3 - H20-28 (HAZ)
Always
Below 1 Ω
H9-4 - Body ground
Always
Below 1 Ω
H9-3 - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
