2014-2019 Hiace · Service Manual TRANSMISSION

DIAGNOSTIC TROUBLE CODE CHART

Diagnostic trouble codes · Vehicles built Oct 2014 – Dec 2014

HINT:
  1. If a DTC is output during the DTC check, check the parts listed in the table below and proceed to the "See page" given.
  2. *1: "Comes on" means the Malfunction Indicator Lamp (MIL) illuminates.
  3. *2: "DTC stored" means the ECM stores the trouble code if the ECM detects the DTC detection condition.
  4. These DTCs may be output when the clutches, brakes, gear components, etc. inside the automatic transmission are damaged.

Automatic Transmission System 
DTC Code
Detection Item
MIL*1
Memory*2
See page
P0705
Transmission Range Sensor Circuit Malfunction (PRNDL Input)
Comes on
DTC stored
Click here
P0712
Transmission Fluid Temperature Sensor "A" Circuit Low Input
Comes on
DTC stored
Click here
P0713
Transmission Fluid Temperature Sensor "A" Circuit High Input
Comes on
DTC stored
Click here
P0717
Turbine Speed Sensor Circuit No Signal
Comes on
DTC stored
Click here
P0722
Output Speed Sensor Circuit No Signal
Comes on
DTC stored
Click here
P0973
Shift Solenoid "A" Control Circuit Low (Shift Solenoid Valve S1)
Comes on
DTC stored
Click here
P0974
Shift Solenoid "A" Control Circuit High (Shift Solenoid Valve S1)
Comes on
DTC stored
Click here
P0976
Shift Solenoid "B" Control Circuit Low (Shift Solenoid Valve S2)
Comes on
DTC stored
Click here
P0977
Shift Solenoid "B" Control Circuit High (Shift Solenoid Valve S2)
Comes on
DTC stored
Click here
P2716
Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT)
Comes on
DTC stored
Click here
P2769
Torque Converter Clutch Solenoid Circuit Low (Shift Solenoid Valve SL)
Comes on
DTC stored
Click here
P2770
Torque Converter Clutch Solenoid Circuit High (Shift Solenoid Valve SL)
Comes on
DTC stored
Click here
← DATA LIST / ACTIVE TEST (Oct 2014 – Dec 2014)P0705 Transmission Range Sensor Circuit Malfunction (PRNDL Input) (Oct 2014 – Dec 2014) →