2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Oct 2014 – Mar 2016

Versions by build date: Oct 2014 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. INSTALL NO. 3 EXHAUST GAS TEMPERATURE SENSOR

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. A239816E01
    Using a 14 mm union nut wrench, install the No. 3 exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

    HINT:
    The sensor has 3 paint marks as shown in the illustration.


2. INSTALL NO. 2 EXHAUST GAS TEMPERATURE SENSOR

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. A239814E01
    Using a 14 mm union nut wrench, install the No. 2 exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

    HINT:
    The sensor has 2 paint marks as shown in the illustration.


3. INSTALL EXHAUST GAS TEMPERATURE SENSOR

NOTICE:
If the sensor is dropped, replace it with a new one.

  1. A239815E01
    Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).

    HINT:
    The sensor has 1 paint mark as shown in the illustration.


4. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(Click here)
← INSPECTION (from Oct 2014)INSTALLATION (Apr 2016 – Dec 2016) →