2014-2019 Hiace · Service Manual CRUISE CONTROL SYSTEM

P0503 Vehicle Speed Sensor Circuit Malfunction

Diagnostic trouble codes · Vehicles built Jan 2015 – Nov 2015

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while cruise control is in operation, the ECM determines there to be a momentary interruption or noise and stores a DTC.
DTC Code
DTC Detection Condition
Trouble Area
P0503
A malfunction in the vehicle speed signal is detected while cruise control is in operation.
  1. Anti-lock brake system
  2. Vehicle speed sensor signal circuit
  3. Vehicle speed sensor
  4. Combination meter assembly
  5. ECM

INSPECTION PROCEDURE


1. CHECK FOR DTC (ANTI-LOCK BRAKE SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    Anti-lock brake system DTCs are not output.



NG
GO TO ANTI-LOCK BRAKE SYSTEM (Click here)
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of 40 km/h (25 mph) or more.

    2. Turn the cruise control main switch on.

    3. Push the cruise control main switch to -SET to activate the cruise control.

  1. Check for DTCs (Click here).

    OK:
    DTC P0503 is not output.

Result 
Result
Proceed to
OK
A
NG (for 2TR-FE)
B
NG (for 1KD-FTV)
C


B
GO TO SFI SYSTEM (Click here)

C
GO TO ECD SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← P0503 Vehicle Speed Sensor Circuit Malfunction (Oct 2014 – Dec 2014)P0503 Vehicle Speed Sensor Circuit Malfunction (Dec 2015 – Mar 2016) →