P0503 Vehicle Speed Sensor Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Dec 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017
DESCRIPTION
If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while cruise control is in operation, the ECM determines there to be a momentary interruption or noise and stores a DTC.| DTC Code |
DTC Detection Condition |
Trouble Area |
| P0503 |
A malfunction in the vehicle speed signal is detected while cruise control is in operation. |
|
- *1: w/ Vehicle Stability Control System
- *2: w/o Vehicle Stability Control System
INSPECTION PROCEDURE
| 1. CHECK FOR DTC (BRAKE CONTROL SYSTEM) |
Check for DTCs.
- w/ Vehicle Stability Control System: Click here
- w/o Vehicle Stability Control System: Click here
- OK:
- Brake control system DTCs are not output.
Result Result
Proceed to
OK
A
NG (w/ Vehicle Stability Control System)
B
NG (w/o Vehicle Stability Control System)
C
- w/ Vehicle Stability Control System: Click here
|
|
||||
|
|
||||
| A | |
| 2. CHECK FOR DTC |
Clear the DTCs (Click here).
Perform the following to make sure the DTC detection conditions are met.
- HINT:
- If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control main switch on.
Push the cruise control main switch to -SET to activate the cruise control.
Check for DTCs (Click here).
- OK:
- DTC P0503 is not output.
| Result |
Proceed to |
| OK |
A |
| NG (for 2TR-FE) |
B |
| NG (for 1KD-FTV w/ DPF) |
C |
| NG (for 1KD-FTV w/o DPF) |
D |
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
