Turbocharger Oil Leak and White Smoke
Circuit diagnosis · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
| Oil Leak Type |
Description |
Main Trouble Area |
| Internal oil leak (White smoke) |
Oil leak from bearing housing to compressor housing (intake side) or turbine housing (exhaust side) through seal rings. Internal oil leak is not visible from outside of turbocharger. If oil leak occurs from turbine side seal, large amount of white smoke will be emitted from exhaust pipe. |
|
| External oil leak |
Oil leak from inside of turbocharger to outside of turbocharger (e.g. from FIPG seal, oil pipe flange or oil pipe union). Includes oil leak visible from outside of turbocharger. |
|
- HINT:
- Turbocharger oil leaks are classified into 2 types. One is an internal oil leak, and the other is an external oil leak.
- When oil leaks and smoke occur, sometimes the turbocharger is mistakenly replaced, even though the turbocharger is not the cause of the problem.
- When there are oil marks on the surface of the compressor housing, or oil in the compressor inlet or outlet, the problem may mistakenly be determined to be a turbocharger oil leak.
- Each part of the turbocharger is shown below.
- Turbocharger oil leaks are classified into 2 types. One is an internal oil leak, and the other is an external oil leak.


| *1 |
Compressor Housing |
*2 |
Seal Ring |
| *3 |
Compressor Inlet |
*4 |
Compressor Impeller |
| *5 |
Bearing Housing |
*6 |
Turbine Shaft |
| *7 |
Oil Drain (Outlet) |
*8 |
FIPG Sealing Part |
| *9 |
Turbine Housing |
*10 |
Turbine Wheel |
| *a |
Internal Oil Leak to Compressor Housing |
*b |
Internal Oil Leak to Turbine Housing |


|
*A |
Fig. 1 |
- |
- |
- HINT:
- Above illustration is an example.
- If the oil stain is similar to the one shown in the illustration (fig. 1), it may be oil spray from parts surrounding the turbocharger or oil leaking from the air cleaner hose. Therefore, this kind of oil stain on the outer surface of the turbocharger is not an oil leak from the turbocharger (external oil leak), and is not related to white smoke. For identification of an actual turbocharger outer oil leak, check only the sealing part shown below.
- Above illustration is an example.


| *A |
Fig. 2 |
*B |
Fig. 3 |
| *a |
Oil Existence at Compressor Inlet (Max. 5 cm3) |
*b |
Oil Existence at Compressor Outlet |
- HINT:
- Above illustration is an example.
- A certain amount of oil is contained in the intake system because blow-by gas containing oil mist is returned to the intake system by the PCV. Therefore, the oil amount at the compressor inlet shown in the left figure (fig. 2) is normal and not an oil leak from the turbocharger (internal oil leak). Also, oil at the compressor outlet as shown in fig. 3 is normal.
In addition, the compressor impeller surface may blacken due to blow-by gas but this is not abnormal.
- Above illustration is an example.


| *A |
Fig. 4 |
- |
- |
| *a |
In the case of an actual oil leak, oil leaks from the sealed part |
*b |
Oil Leak Check Point (FIPG Sealing Part) |
- HINT:
- Above illustration is an example.
- This is an illustration (fig. 4) of an air leak test performed by applying soapy water to the area of the leak. Bubbles indicate the leak point.
- Above illustration is an example.
| Faults and Symptoms of Turbocharger Parts |
| Main fault |
Seal ring breakage |
|
| Symptoms |
|
|
| Note |
|
|
| Main fault |
Seal ring breakage |
|
| Symptoms |
|
|
| Note |
|
|
| Main fault |
Oil drain clogging by coked oil |
|
| Symptoms |
Large amount of white smoke from exhaust pipe |
|
- HINT:
- Oil coking is caused by insufficient oil maintenance.
- If the oil drain is clogged by coked oil, oil cannot be drained smoothly, and it overflows from the bearing housing to the compressor housing and turbine housing. This results in a large amount of white smoke from the exhaust pipe.
If any solid (coked oil) is visually confirmed inside the bearing housing, it can be assumed to be the cause of internal oil leak.
- Oil coking is caused by insufficient oil maintenance.
-


Text in Illustration *1
Oil Drain
-
-
*a
Coked Oil
*b
Oil Drain Clogged with Coked Oil
- HINT:
- Above illustration is an example.
| Main fault |
|
|
| Symptoms |
|
|
| Note |
|
|
| Main fault |
Breakage |
|
| Symptoms |
|
|
| Note |
|
|
| Symptoms |
Oil leak from FIPG sealing part |
|
| Note |
|
|


| *1 |
Compressor Back Plate |
*2 |
FIPG Sealing Part |
| *3 |
Compressor Housing |
- |
- |
| *a |
Oil Leak |
*b |
Oil Leak from FIPG Sealing Part |
- HINT:
- Above illustration is an example.
| Symptoms |
Oil leak from hose connection between hose and compressor housing |
|
| Note |
If oil stain is traced to hose connection part, it can be determined to be due to hose connection failure. |
|


| *A |
Fig. 5 |
- |
- |
| *1 |
Compressor Outlet |
*2 |
Compressor Housing |
| *a |
Trace of Oil Leak from Hose Connection Part |
*b |
Oil Leak from Hose Connection Part |
- HINT:
- Above illustration is an example.
INSPECTION PROCEDURE
| 1. CHECK TYPE OF OIL LEAK |
Check whether the oil leak is an internal or external oil leak.
- HINT:
- White smoke is not related to an external oil leak.
Oil Leak Type
Description
Internal oil leak
(White smoke)
Oil leak from bearing housing to compressor housing (intake side) or turbine housing (exhaust side) through seal rings.
Internal oil leak is not visible from outside of turbocharger.
If oil leak occurs from turbine side seal, large amount of white smoke will be emitted from exhaust pipe.
External oil leak
Oil leak from inside of turbocharger to outside of turbocharger (e.g. from FIPG seal, oil pipe flange or oil pipe union).
Includes oil leaks visible from outside of turbocharger.
Result Result
Proceed to
External oil leak
A
Internal oil leak
B
|
|
||||
| A | |
| 2. REPLACE THE PART WHICH IS LEAKING OIL |
Replace the part which is leaking oil.
| NEXT | ||
| ||
| 3. CHECK WHETHER WHITE SMOKE IS EMITTED |
Fully depress the accelerator pedal, and then release it.
Check whether white smoke is emitted or not when racing the engine.

- CAUTION:
- Be sure not to check for white smoke indoors.
Result Result
Proceed to
White smoke is emitted
A
White smoke is not emitted
B
|
|
||||
| A | |
| 4. READ OUTPUT DTC (RELATED TO ENGINE) |
Connect the GTS to the DLC3.
Turn the ignition switch ON and turn the GTS ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
Result Result
Proceed to
No DTCs are output
A
DTCs related to engine are output
B
|
|
||||
| A | |
| 5. CHECK WHITE SMOKE (ACCORDING TO ENGINE CONDITION) |
Check whether the white smoke is emitted only just after engine start and disappears later, or not.

- HINT:
- If white smoke appears for only a short period of time immediately after the engine is started, the white smoke is not from the turbocharger.
- If the turbocharger is the cause of the problem, regardless of whether the engine is cold or warmed up, there will be a large amount of white smoke to the extent that visibility is obstructed for a few meters in the area of the smoke (as shown in the illustration).
- Depending on whether there is oil mixed with the fuel, or whether there is unburned fuel present, the smell of the exhaust gas differs. When oil is mixed in, the exhaust gas smells like burning oil.
- If white smoke appears for only a short period of time immediately after the engine is started, the white smoke is not from the turbocharger.
Result Result
Proceed to
Yes (white smoke is emitted only just after engine start)
A
No (white smoke is always and continuously emitted)
B
|
|
||||
| A | |
| 6. CHECK TEMPERATURE WHEN WHITE SMOKE IS EMITTED |
Check whether the white smoke is emitted only in cold weather when the temperature is less than 0°C (32°F).
- HINT:
- If the white smoke is emitted only in cold conditions, the smoke is not from the turbocharger and may be the smoke of unburned fuel.
- If misfiring occurs, unburned fuel is emitted.
- If the white smoke is emitted only in cold conditions, the smoke is not from the turbocharger and may be the smoke of unburned fuel.
Result Result
Proceed to
Yes (white smoke is emitted in only cold conditions)
A
No (white smoke is emitted in both cold and warm conditions)
B
|
|
||||
| A | |
| 7. INSPECT GLOW PLUG ASSEMBLY (RESISTANCE) |
Inspect the glow plug assembly (Click here).
|
|
||||
| OK | |
| 8. CHECK INJECTOR COMPENSATION CODE |
Read the injector compensation codes (Click here).
- OK:
- Compensation codes stored in the ECM match compensation codes of the installed fuel injectors.
- HINT:
- If those do not match, register correct compensation code.
- If those do not match, register correct compensation code.
|
|
||||
| OK | |
| 9. CHECK FUEL SYSTEM (DIESEL INJECTION SYSTEM) |
Check the fuel system (Click here).
|
|
||||
| OK | |
| 10. CHECK CYLINDER COMPRESSION PRESSURE |
Check the cylinder compression pressure (Click here).
- HINT:
- If any of following malfunctions occurs, white smoke is emitted.
- Nozzle seat sealing failure
- Piston cracking
- Piston rings breakage
- To check whether the pistons and piston rings have a malfunction, remove the oil level dipstick. If oil sprays out, the pressure inside the crankcase has risen which indicates that there is a malfunction in a piston or piston ring.
- If any of following malfunctions occurs, white smoke is emitted.
|
|
||||
| OK | |
| 11. REPLACE TURBOCHARGER SUB-ASSEMBLY |
Replace the turbocharger sub-assembly (Click here).
| NEXT | |
| 12. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Check whether the white smoke problem has been successfully repaired by starting the engine.
| NEXT | ||
| ||
| 13. INSPECT COMPRESSOR INLET |
Remove the air cleaner hose from the compressor inlet (remove the compressor inlet elbow if necessary).
Check whether an excessive amount of oil is present or not, and whether excessive oil deposits are attached to the compressor impeller or not.
- HINT:
- A certain amount of oil may be present as shown in fig. 2 in "Description", because a certain amount of oil mist is contained in the PCV gas and this oil accumulates just before the compressor inlet.
- If an excessive amount of oil is present at the compressor inlet, there may be a problem in the PCV system.
- A certain amount of oil may be present as shown in fig. 2 in "Description", because a certain amount of oil mist is contained in the PCV gas and this oil accumulates just before the compressor inlet.
Reinstall the air cleaner hose (compressor inlet elbow).
| NEXT | |
| 14. INSPECT COMPRESSOR OUTLET |
Remove the air hose from the compressor outlet.
Check whether or not an excessive amount of oil or excessive oil deposits are present at the compressor outlet.
- HINT:
- A certain amount of oil may be present as shown in fig. 3 in "Description", because a certain amount of oil mist is contained in the PCV gas.
Result Result
Proceed to
Excessive amount of oil present at both compressor inlet and outlet
C
Excessive amount of oil present only at compressor outlet
B
Excessive amount of oil not present at compressor inlet and outlet
A
Reinstall the air hose.
|
|
||||
|
|
||||
| A | |
| 15. INSPECT TURBINE INLET |
Remove the turbocharger from the engine.
Check whether an excessive amount of wet oil or excessive oil deposits are present at the turbine inlet.
- HINT:
- Be sure not to mistake carbon soot for oil.
| NEXT | |
| 16. INSPECT TURBINE OUTLET |
Check whether an excessive amount of wet oil or excessive oil deposits are present at the turbine outlet.
- HINT:
- Be sure not to mistake carbon soot for oil.
- If the turbocharger shaft is tilted, some amount of oil will flow out from the bearing housing. Therefore, be sure not to mistake oil that flowed out from the bearing housing during or after the removal of the turbocharger for oil that was present before the removal of the turbocharger.
- If an excessive amount of oil or excessive oil deposits are present at the turbine inlet, this oil is coming from the exhaust port of the cylinders, and may indicate a problem in 1 or more cylinders.
- Be sure not to mistake carbon soot for oil.
Result Result
Proceed to
Excessive amount of oil present at both turbine inlet and outlet
B
Excessive amount of oil present only at turbine outlet
A
|
|
||||
| A | |
| 17. REPLACE TURBOCHARGER SUB-ASSEMBLY |
Replace the turbocharger sub-assembly (Click here).
| NEXT | |
| 18. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Check whether the oil leakage problem has been successfully repaired.
| NEXT | ||
| ||
